Laser engraver Decaker 1500mW

Loading the image into the controller’s memory still comes from the computer. This is a new generation of NEJE type engravers, only with an increased working field up to 8x8cm. This is quite an interesting laser with different mechanics compared to NEJE/Meterk/Kkmoon. Greetings to all Mysku visitors! Control is carried out via USB cable, additionally there is manual control (start-pause, carriage movement). On the agenda is the Decaker 1500mW laser engraver This is a low power laser engraver (~1500 mW) of a closed type. On the top right are the power and microUSB connectors. And there is a slightly different association, perhaps the manufacturer specifically sought this. For example, on a cutting board. Special greetings if you recognize the HPP. Specifically, I will compare with the DK-BL-1500

Laser engraver Decaker 1500mW


But nevertheless, the engraver is interesting. There are no wireless interfaces in this model. There is no lower face (bottom).
There is a fan on the back (smoke removal is a good idea). It looks like a plastic portal cube with legs. A small review of the laser engraver Decaker 1500mW. The gantry design of the engraver, coupled with some design elements, looks a lot like the valve lifters of a hydroelectric dam. A wide protective glass is installed on the front part (also a good idea). Hello everyone. The windows are open on the left and right, you can adjust the focus, correct the material, etc. The dimensions of the engraver: 155×166 mm, height 143 mm. One of the obvious https://jiji.ng/oyo/dogs-and-puppies/boerboel advantages of this design: the laser engraver can be installed on large flat surfaces for engraving in parts. On the top side there are buttons for manual control of engravers. To be honest, when I first saw him, I had associations in appearance.
The review will mainly compare the design, since the power is the same with NEJE (since a similar laser module is installed)

Leave a Reply

Your email address will not be published. Required fields are marked *